I want to receive a message in my modem TD1208 (using Akene + Arduino UNO)
To do so, I have configurated a callback using Mockbin : I use a BIDIR callback, but when I press ok a message on the top says "A bidir callback exists, but the device type is in DIRECT downlink mode. You should change it to CALLBACK" ==> Is it a problem ? How to solve ?
Then when I look to the callback list, the downlink check box is not checked ==> Is it a problem ? How to solve ?
Then when I run my Arduino sketch, I receive a message (0x000027b20123ff81). This message correspond to the one in the message list correponding to this Device. But, it does not correspond to the message I wanted to send using my Callback... (0x0700000000000000)
Answer by pierre · Dec 23, 2016 at 04:33 PM
When you want to use a callback for downlink, you first have to configure the device type with CALLBACK as a downlink mode.
Here the device receives the message configured in the DEVICE TYPE configuration, as defined in the DIRECT mode.